Settings
a/b-Audiobox - Operation Guide - V03 10/2020
23
Setting the Input Sensitivity of the a/b Line
You can use this programming to configure the a/b-Audiobox to suit PBXs from
other manufacturers that have different attenuation. This is necessary in the fol
-
lowing situations, for example:
• There is no busy signal detection i.e. when the receiver is put down, the
a/b-Audiobox does not end the call.
Requirements:
– Connection has been made to the internal a/b port on a PBX
– An internal telephone number has been set up for the a/b-Audiobox on the
PBX
– Knowledge of the PIN (0000 in the factory settings)
– DTMF-enabled internal telephone or DTMF tone generator
– Programming mode has been initiated (by pressing and holding the pro
-
gramming key for five seconds)
1.
Pick up the receiver of an internal telephone.
2.
Dial the internal telephone number of the a/b-Audiobox.
This establishes the connection.
3.
Dial
*
.
You will hear the confirmation tone (five sequential tones).
Note:
If you only hear a short sound instead of the confirmation tone (after
restarting programming mode), enter the PIN and then dial
*
again.
4.
After the confirmation tone ends, dial one of the following character strings.
500
: Sets the input sensitivity to level 0 (low).
501
: Sets the input sensitivity to level 1 (factory settings).
...
509
: Sets the input sensitivity to level 9 (high).
You will hear the confirmation tone (five sequential tones).
The a/b-Audiobox continues to be in programming mode. For ad
-
ditional programming actions, begin with the 3rd step.