11
8.1
Maintenance and adjusting ALL-IN-SEALER
In order to be able to carry out maintenance or to replace spareparts easily you should:
−
Disconnect the ALL-IN-SEALER from the power supply
−
Loosen the two knobs under the transport belt, and move the transport belt as far as possible from the
ALL-IN-SEALER.
−
See fig. 5. -
Remove the back cover (1).
-
Open the upper front cover (2).
-
Remove the lower front cover (3).
Take care! The heating plates can still be hot. Before switching off the cooling ventilator and the
motor, the machine must cool down for at least 10 minutes!!
When all activities have been done, remount the rear cover and the protection covers.
DO NOT OPERATE THE MACHINE IF THE PROTECTION COVERS HAVE NOT BEEN MOUNTED.
Fig. 5
Summary of Contents for D 555 NH
