AudioControl DQ-61, User Manual

Page: 19 / 32

-----------------------------------------------19 ----------------------------------------------
4.
Now you need to carefully choose the source material to listen to
while setting the delay. Choose a song that has very strong vocals
and limited instruments. This will make it much easier to “move”
the image from down at your left knee where it currently exists
to up on the center of the dash where it needs to be.
5. Left / Right Delay: Push on the dash remote until the blue LED is
blinking and the red LED is solid. With the source material play -
ing, slowly turn the ACR-3 dash control knob COUNTER CLOCK -
WISE. Each detent in the remote represents an amount of time
(in milliseconds) that you are delaying the Left Front Speaker. We
have added a small Mute Click along with the detent on the re -
mote to help you determine your amount of delay. Keep in mind
that if you think you have gone too far you can always start over.
Just turn the knob all the way clockwise to start back at zero and
slowly turn counter clockwise until you reach your desired result.
6. Front/Subwoofer Delay: Once you have dialed in your Left /
Right delay, it’s time to set up the sub. Push on the dash remote
to switch delay modes and verify that the blue LED continues
to blink but the red LED is off. Exactly like you did setting up the
front left speaker, start by slowly turning the knob counter clock -
wise to add delay to both of the front speakers. You will notice
with each Mute Click of the remote, the sub will move forward
toward the driver. Again, if you think you have gone too far or
missed that ‘sweet spot’ you can always start over by just turning
the knob back all the way clockwise and repeat the process
again.
Once you have everything where you want it you are done! Easy right?
Now just go back to the Signal Delay knob on the DQ-61 and turn it
counter clockwise back to Normal mode and you are ready to move to
the next step of set-up.