28
Navigating the Set-Up Menus
Concert XR series
Video Inputs
If desired, you can assign a video source to each of the “audio only” inputs.
The default for each of these settings is “None”. This is a great way to listen
to the ball game over the Internet Radio and watch it over your normal video
display device, though timing might be a little off.
HDMI Settings
The Concert XR series is not only a great sounding home theater processor
but it is also a very powerful video processor. To that extent it has a number
of video settings that need to be selected carefully to optimize your video
performance.
Zone 1 OSD : This selects the pop-up text messages to be On or Off.
When On, any adjustments made on the unit (like volume, mute state
changes, sub trim level) will be shown on your display screen, as well as
on the unit’s front panel display.
When Off, any adjustments will only be shown in the unit’s front panel
display. This leaves your screen clear from interruption. However, the
set up screen overlay will always be shown when working through the
menus.
Lipsync (Information Only): When this feature is supported by the display
device, this setting displays how much lip sync is applied to HDMI Outputs.
HDMI Audio to TV: Use this to set audio to be sent to the TV
HDMI Bypass and IP: Sets the state of IP control and HDMI bypass of the unit
while in Standby. When in Low Power mode, network or IP control and HDMI
bypass are disabled. With HDMI & IP On, the unit will respond to IP control
when in standby and HDMI bypass is enabled.
HDMI bypass Source: Specifies the source used when HDMI bypass is on.
Specific inputs can be specified or the last input used.
CEC Control: Turns CEC control on or off
eARC Control: Turns off automatic volume control from the display
TV Audio: enables auto-switching to eARC audio from the display
Power Off Control: Turns off automatic power control from other CEC devices
