AudioControl 7.1 Channel THX Ultra 2 Theater Processor, Manual

Page: 34 / 78

Maestro
tm
Phone 425-775-8461 • Fax 425-778-3166
®
Configuration
Section
3-10
L L L L Local OSD ocal OSD ocal OSD ocal OSD ocal OSD – Selects if the On-Screen Display of the zone 2
video output is On or Off.
Zone 1 Control Zone 1 Control
Zone 1 Control Zone 1 Control Zone 1 Control – Selects if the Zone 2 IR input is allowed
to control the Main Zone volume and source selections.
A A A A Access ccess ccess ccess ccess – This limits which sources are available to Zone 2.
To set this option: Press the source input buttons to toggle
a selection on or off.
ADV 5 – Input Trims
Adjusting the Source Unit Input V Adjusting the Source Unit Input V Adjusting the Source Unit Input V Adjusting the Source Unit Input V Adjusting the Source Unit Input Volume T olume T olume T olume T olume Trims rims rims rims rims – The
input trims allow the installer to match the relative vol-
umes of all sources and get the highest usable dynamic
range. These trims affect only the two channel analog
audio inputs from each source. There is no change to the
digital audio levels. The reference 2 volt setting should be
appropriate for most sources. To check the levels for a
source:
1.Find a loud music selection or use a 0 dB reference disk.
2.Watch the bottom of the Maestro screen for the “Clip”
indication.
3.If there is a “Clip” indication, turn up the Input Trim
level to 4V or 8V until the clip indicator goes out.
4.If a source is quieter than the others, turn the Input Trim
level down to 1V. Play a loud music track or use a 0dB
reference disk to verify that the “Clip” indication does
not come on at this setting.
Adv 5 - Inputs Trims
Aux: Reference 2V
DVD: Reference 2V
Sat: Reference 2V
AV: Reference 2V
VCR: Reference 2V
Tape: Reference 2V
CD: Reference 2V
Tuner: Reference 2V
DVD-A: Reference 2V