Mediant 9000 Series SBC
Hardware Installation Manual
16
Document #: LTRT-41667
3.2.1 Front Panel LEDs
The front panel LEDs are shown in the figure below and described in the subsequent table.
Figure 3-2: Front Panel LEDs
Table 3-3: Front-Panel LEDs
Item #
Description
Status
1
UID LED/button*
•
Solid blue = activated.
•
Flashing blue = Remote management or firmware
upgrade in progress.
1 Hz = Remote management or firmware upgrade
in
progress
4 Hz = iLO manual reboot sequence initiated
8 Hz = iLO manual reboot sequence in progress
•
Off = deactivated.
2
Power On/Standby
button/LED and
system power
LED*
•
Solid green = System on
•
Flashing green = Performing power on sequence
•
Solid amber = System in standby
•
Off = No power present**
3
Health LED*
•
Solid green = Normal
•
Flashing green = iLO is rebooting
•
Flashing amber = System degraded
•
Flashing red = System critical†
4
NIC status LED*
•
Solid green = Link to network
•
Flashing green = Network active
•
Off = No network activity
*When all four LEDs described in this table flash simultaneously, a power fault has occurred.
**Facility power is not present, power cord is not attached, no power supplies are installed,
power supply failure has occurred, or the power button cable is disconnected.
†If the health LED indicates a degraded or critical state, review the system IML or use iLO
to review the system health status.
Summary of Contents for Mediant 9000 Rev. B
Page 2: ......
