AudioCodes Mediant 1000B, Hardware Installation Manual

Page: 17 / 70

Hardware Installation Manual 3. Physical Description
MSBR Series 17 Mediant 1000B MSBR
3.2 Front Panel Description
The device's front panel is shown in the figure below and described in the subsequent
table.
Figure 3-1: Front Panel
Notes:
•
The figure above is used only as an example. The number and type of interface
modules depends on the ordered configuration.
•
For module slot assignment, see Section 6.1.1 on page 51 .
Table 3-2: Front-Panel Description
Item #
Label/
Module
Component Description
1 FXS FXS module – see Section 3.2.1 on page 18 for a description.
FXO FXO (or FXO G) module – see Section 3.2.2 on page 19 for a
description.
BRI BRI module – see Section 3.2.3 on page 20 for a description.
TRUNKS TRUNKS (E1/TE/J1) module – see Section 3.2.4 on page 21 for a
description.
2 MPM MPM module – see Section 3.2.5 on page 22 for a description.
3 CRMX CRMX module – see Section 3.2.6 on page 23 for a description.
4 - This slot is currently not used and is covered by a blank panel. In
the next applicable release this slot is intended to host a LAN
extension module (for more information, contact AudioCodes
sales representative).
5 Power 1 (Optional) Spare Power Supply module slot. The device can
provide two extractable power supply units (Power 1 and Power
2). Each power supply unit provides an AC power connector on
its rear panel. If both Power 1 and Power 2 units are used, the
load is shared between them. This (optional) load-sharing feature
enables power failure protection (redundancy). When using this
feature, you are advised to connect each power supply unit to a
different AC supply circuit.
6 Power 2 Main Power Supply module (see description above).