AudioCodes Mediant 1000B SBA, Installation And Maintenance Manual

Page: 217 / 298

Installation & Maintenance Manual 30. SBA Upgrade and Recovery
Version 6.8 217 Microsoft Lync Server
30 SBA Upgrade and Recovery
After you have customized the SBA upgrade and recovery process using the
RecoveryUtil.ini file (see Section 29 ), you can start the upgrade and recovery process. The
process can be done with or without online monitoring.
Note: When the process completes, you can view the results of the SBA upgrade and
recovery process in the log file RecoveryLog.txt. This file is located on the USB dongle.
Warnings: Before proceeding, note the following:
• Contact your AudioCodes representative to verify if there are any required updates to
the OSN's BIOS.
• Enter the OSN server's BIOS setup and set the highest boot priority to the USB
dongle and not the HDMX.
30.1 Upgrading or Recovering without Monitoring
The procedure below describes how to start the SBA upgrade and recovery process
without monitoring.

To start SBA upgrade and recovery without monitoring:
1. Open (using a text editor such as Notepad) the RecoveryUtil.ini file and then set the
OnExit parameter to 2 so that the OSN server shuts down upon SBA upgrade and
recovery completion:
[Execution] OnExit = 2
2. Save and close the RecoveryUtil.ini file.
3. Plug the USB dongle into the USB port OSN on the Mediant 1000B OSN
module, as shown below: