88
8
F1/F2
Selects between the two banks of 16 frequencies; see
Selecting the operating frequency
, page 9.
Headphone level
Adjusts the headphone level output. Use a small
screwdriver to turn the control.
Top panel
Antenna 2
Rack connector
Audio
output
Antenna 1
Audio output
Provides balanced microphone level and adjustable
headphone outputs.
Antenna 1/Antenna 2
SMA sockets to which the antennae are connected.
Rack connector
The multiway connector is for use with the DK 2000 and
the RK 2 rack systems.
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
Setting up the DX 2020
To set up the DX 2020 in conjunction with a TX 2020 or
HX 2000:
• Fit the batteries.
• Set the transmitter and receiver to the same
operating frequency.
• Connect the RX1 and RX2 antennae.
• Switch on.
• Connect the audio output cable.
• Check that one of the RX1 and RX2 indicators is
illuminated, and that the ‘No signal’ indicators are not
illuminated.
These steps are explained below:
Fitting the batteries
To open the battery compartment, press the release
button and flip the cap. Insert three DL123A 3 volt
Lithium batteries, negative contact first as shown on the
side of the unit, and close the cover. Do not use
excessive force.
DX 2020 Receiver
Summary of Contents for RMS 2020
Page 1: ......