Audio RMS 2020, User Manual

Page: 15 / 31

88
15
reduction of wind noise.
Gain
Provides ten gain options; 0 gives minimum gain, and
each position increases the gain by approximately 4dB
giving a total of 40dB of adjustment.
Operation indicator
Indicates amber when the unit is on and the battery
voltage is within the working range. The indicator will go
out when the battery voltage is low; although the HX
2000 will continue to operate for a short time after this,
the battery should be replaced as soon as possible.
Overload indicator
Indicates that the low-distortion overload limiter is
operating.
F1/F2
Selects between the two available operating
frequencies; see Selecting the operating frequency
below.
Power locking ring
Locks the battery compartment to prevent accidental
switching off while in use.
Battery compartment
Holds one DL123A 3 volt Lithium battery.
Antenna
The optional antenna screws in the base of the battery
compartment.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Setting up the HX 2000
To set up the HX 2000 in conjunction with a DX 2020:
• Fit the battery.
• Set the transmitter and receiver to the same
operating frequency.
• Connect the antenna (optional).
• Switch on by turning the battery compartment until
the operation indicator lights up.
• Lock into position with the locking ring.
• Set the gain.
• Check that the receiver’s ‘No signal’ indicators are
not illuminated.
HX 2000 Hand Held
Transmitter