33
Rev.2.10
Troubleshooting
Symptom
Cause/solution
No reception
Does the POWER LED light?
>> Check the connection between the receiver and the
amplifier.
Check the power of the amplifier is turned on
Is the power of the microphone turned on (Is a battery
loaded)?
>> Turn on the power of the microphone (load a battery) to put
it into the transmissible state.
No sound generated
Does the reception LED indicator MIC1 or MIC2 light?
>> If the microphone is not normally receivable, the reception
LED indicator does not light.
The audio output of LINE IN is not provided.
>> Is audio output of the device connected to LINE IN ready to
be provided?
No audio output of the microphone or LINE IN is provided.
>> Isn’t the page mute signal input provided to this unit?
If the page mute signal input is provided, the audio output from
this unit is muted. The 3 LEDs of this unit light yellow while the
page mute function is activated.
Is the volume setting equipped in this unit set to the lowest
level?
>> The volume of the microphones MIC1 and MIC2 and LINE
IN equipped in this unit can be adjusted by K-STD14 and
through external communication control.
The volume of the mixing output fluctuates.
>> When the microphone override function is active, an audio
input to the microphone (MIC1 or MIC2) attenuates the audio
level provided to LINE IN.
Audio interrupted
Isn’t the feedback blocker activated?
Adjust the speaker output to the lower level so as to avoid the
feedback.
LINK indicator (red)
It has been unable to register with the WAP
>> Please ask an administrator.
LINK indicator (red)
System Error
>> Please ask an administrator.
LINK indicator (yellow)
Receiver Trouble
>> Please ask an administrator.
RCV repeats the reboot
RCV and WAP connection might be off.
>> Please contact your administrator.
