Dante-MY16-AUD User Guide Version 1.41
Page 39 of 46
How can I check whether I AM using Gigabit Ethernet?
The Orange, right hand side Gigabit LED will be lit:
The Primary Link Speed of the card in the Device Info tab in Dante Controller shows 1Gbps
PC / Mac network configuration
Dante hardware devices are set to obtain their IP address automatically from the network. They will either:
Automatically assign themselves an address in the range 169.254.*.* (172.31.*.* for the secondary
network if present), or
Obtain an IP address from a DHCP server if it is present on the network
You can also specify a static IP address for one or both network interfaces via the Device View > Network Config
tab.
The PC or Mac must have a correct IP address (or addresses, if you are connecting to the network via two
interfaces).
How do I check which interfaces Dante Controller/Dante Virtual Soundcard is using?
The selected network interfaces can be viewed or changed via the 'interface selection' button
in
the Network View toolbar of Dante Controller
How do I check what IP addresses Dante Controller is using?
The IP addresses can be viewed in the
Configure Dante Interfaces
dialog box brought up by the
'interface selection' button
:
If the Dante network is standalone and does not have a DHCP server installed, the primary address
should be 169.254.*.* and the secondary address (if connected) should be 172.31.*.*
If the Dante network is using a DHCP server, the IP address es should conform to the addressing
scheme it is using (as in the image above)
How do I check what IP address my Dante-MY16-AUD card is using?
IP addresses configured for all Dante devices on the network can be viewed via the
Device Info
tab in
Dante Controller
