Dante-MY16-AUD User Guide Version 1.41
Page 27 of 46
The available modes are:
Mode
Name
Description
Mode 1
Slot ↔ DB9 Active,
Network Inactive
HA Remote data is bridged between the host device and the
DB9 ('Serial') port on the Dante-MY16-AUD card, but is not
transmitted across the Dante network.
Mode 2
Slot ↔ Network
Active, DB9 Inactive
HA Remote data is bridged between the host device and the
Dante network (via the Dante Ethernet ports), but is not
bridged to the DB9 ('Serial') port on the Dante-MY16-AUD card.
Mode 3
DB9 ↔ Network
Active, Slot Inactive
HA Remote data is bridged between the DB9 ('Serial') port on
the Dante-MY16-AUD card and the Dante network, but is not
bridged to the host device.
Mode 4
All Inactive
HA Remote data is not bridged at all. This is the default mode.
For information about the most suitable HA Remote mode for your device, please see the table below.
HA
Remote
Mode
Yamaha Product Models
CL1/3/5
QL1/5
M7CL-
48ES
LS9
PM5D
M7CL-
32/48
DM2000
DM1000
DME64N
DME24N
Other MY-
compatible
models
1
2
(as an HA
device)
3
(as a
controller)
(as an MY
card host)
4
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
Special Considerations
Some Yamaha devices (listed below) do not bridge HA Remote control data directly from the host device to an
installed Dante-MY16-AUD card. For these devices, use a straight-through male-to-female DB9 (DE9) cable to
connect the REMOTE port on the host device to the Serial port on the Dante-MY16-AUD card, and select HA
Remote Mode 3 in Dante Controller for the Dante-MY16-AUD card. Then connect the device to the network switch
using the Primary Ethernet port on the Dante-MY16-AUD card.
Affected devices:
DM1000
DM2000
PM5D
M7CL
‐
32/48
DME24N
DME64N
