Audient ASP2802, Operating Manual, Page: 75 / 113

Page -75- © Audient Ltd
ASP2802 features a plethora of connections on the rear panel -
as highlighted during the introduction of this manual.
All XLR balanced input and outputs are wired as Pin 1 (shield -
chassis / shield ground), Pin 2 (hot +ve) and Pin 3 (cold -ve).
Channel Strip Inputs and Outputs
The first input from (top to bottom) is the
MICROPHONE XLR INPUT (female). The input
impedance of the microphone input is
greater than 2.5k ohms and the maximum
input level is approxi16 dBu (where
0 dBu is referenced to 0.775 V
rms
).
The next connection is the channel LINE
INPUT , a balanced TRS with an input
impedance of >10k ohms and a maximum
operating level of +27 dBu. This and all
other TRS jacks are wired as Tip (+ve),
Ring (-ve) and Sleeve (shield).
The INSERT SEND jack comes next, a
balanced TRS connector fed from an
impedance balanced output with an
output impedance of 150 ohms and
a drive capability of +21 dBu.
The INSERT RETURN TRS jack is also fully
balanced with a >10k ohm input impedance
and a maximum input level of +21 dBu.
The remaining channel strip connections ( DAW Inputs and Direct
Outputs ) are found on 2 8-way DB25 female connectors at the
bottom of the rear panel. These are wired to Tascam DA-88
25-pin D-SUB standard (see next page). The
DAW Inputs and
Summing Inputs have a balanced input impedance of >10k
ohms and a maximum input level of +27 dBu.
Connections