AUBER INSTRUMENTS
WWW.AUBERINS.COM
2015.06
P5/5
key to confirm. The display will show “JUMP” for a
second and then the
controller will start executing the specified program step.
11.
Connect the Sensor to the Controller
The connector of sensor contains a slot for fitting pin connection. It also has a
spring lock to prevent disconnections from accidental pulling on the cable.
To install the sensor to the controller: 1) Identify the key on the male sensor
connector (Figure 5, a) and the notch on the female connector (Figure 5, b). 2)
Hold the tail of the female connector, align the notch and the key, and push the
female connector forward.
To remove the connector, hold the spring loaded collar on the female
connector and pull it back. Please see Figure 6.
(a)
(b)
(c)
Figure 5. Install the sensor.
Figure 6. Remove the sensor.
Auber Instruments
5755 North Point Parkway, Suite 99
Alpharetta, GA 30022, USA
E-mail: [email protected] Tel: 770-569-8420
