ATX 22 Type-S, Owner'S Manual

Page: 47 / 100

FEATURES | 46
SWITCHES, CONTROLS, PORTS, GAUGES AND INDICATORS
Switches
The switches are fitted with LEDs, which will illuminate when power is being
supplied to the corresponding switch and its function .
BILGE (Bilge Pump)
This switch operates the bilge pump to remove excess water from the bilge area
of the boat manually . When the switch is pressed on, the bilge will turn on . When
the bottom is pressed off, the bilge will turn off .
Your ATX boat is equipped with an automatic bilge pump which detects excess
water accumulation and will turn the bilge pump on automatically . The switch
does not have to be on for the automatic system to work . This switch can also
be used to test the bilge pump, by listening to hear that the pump is operating .
It may not pump water unless water is present . Do not operate the bilge pump
continuously when it is dry .
Inspect the bilge area frequently for evidence of excessive water . Continuous
operation of the bilge pump can mean there is excess water in the bilge . Test the
bilge pump at regular intervals . Debris can also prevent the pump from oper-
ating or make it operate continuously . Make sure no debris is blocking the bilge
pump float . See your ATX Dealer if you have any questions .
BLOWER (Engine Compartment/Bilge Area Blower)
This switch operates the engine compartment ventilation blower to remove
explosive fumes from the area . When the blower switch is pressed on, the blower
will turn on . When the blower switch is pressed off, then the blower will turn off .
The blower must be operated for a minimum of four minutes before starting the
engine . Also, the blower should be operated continuously when at idle or running
at slow speeds .

DANGER
Gasoline vapors can explode resulting in serious injury or death .
• Before starting engine, check the engine compartment for gasoline or gaso-
line vapors, then run blower for 4 minutes .
• Run blower below cruising speed .
COURTESY (Courtesy Lights)
This switch operates the courtesy lights . When the switch is pressed on, the lights
will turn on . When the switch is pressed off, then the lights will turn off .
DOCKING (Docking Lights
This switch operates the docking lights . The docking lights are to be used
for docking only;
DO NOT
use them while cruising . When the switch is pressed
on, the lights will turn on . When the switch if pressed off, the lights will turn off .
NAV (Navigation Lights)
This switch operates the navigation lights . When the switch is pressed on, the
lights will turn on . When the switch is pressed off, then the lights will turn off .

WARNING
LOSS OF CONTROL AND UNSAFE BOAT HAZARD
An emergency stop switch system that is not used or does not function
properly can cause death or serious injury .
DO NOT
operate the boat if the
emergency stop switch system does not function properly .