ATTO Technology iPBridge 1550, Installation And Operation Manual

Page: 62 / 72

53
ATTO Technology Inc. iPBridge Installation and Operation Manual
7.1.9 Target management commands
Use the default mapping or map target devices using ATTO ExpressNAV. The commands in this chapter
provide additional information and specific CLI commands you may use if mapping using the Ethernet
or serial port. Refer to
Target management on page 13.
AccessControl
Controls access to a target node as keyed to the iSCSI
qualified name of listed initiators.
Note
AccessControl cannot be used with iSNS.
Refer to
iSNSLoginControl on page 52.
set AccessControl [default | Target Name] [enabled |
disabled]
get AccessControl [default | Target Name]
AccessEntry
Allows the addition or deletion of an initiator entry from
the access control list of a target node. The initiator name
must be an iSCSI qualified name and must be between 1
to 223 characters. The name is case sensitive and cannot
be
all.
set AccessEntry [default | Target Name | discovery]
[Initiator Name <delete> | all [delete]]
get AccessEntry [default | Target Name | discovery]
AutoMap
Automatically assigns iSCSI LUNs to a set of SCSI target
destination devices visible to the iPBridge.Automap with
no arguments maps all drives to the default target. By
specifying a target name,
Automap maps all devices to
that target. By specifying * , automap maps each device
to its own auto-named target.
AutoMap < default | Target Name | * >
AutoMapOnBoot
Controls automatic device detection and mapping
(automap) at bridge startup.
Default: enabled
set AutoMapOnBoot [enabled | disabled]
Requires a SaveConfiguration command
get AutoMapOnBoot
AutoMapOnBootDelay
Controls automatic device detection and mapping
(automap) at bridge startup with a delay of up to 4.25
minutes (1-256 seconds).
set AutoMapOnBootDelay [0-256]
Requires a SaveConfiguration command
get AutoMapOnBootDelay
DeleteAllMaps
Removes all mapped devices from the map table. Upon
the subsequent POST, if no maps are present the default
maps will be loaded.
DeleteAllMaps
iSCSITarget
Creates/deletes an iSCSI target name. The target name
acts as a suffix to the standard iPBridge iSCSI-qualified
name. The target name may not exceed 24 characters. A
newly-created target has one LUN, the iPBridge LUN, at
LUN 0. If the target name already exists, this command
does nothing. Access control is enabled by default unless
iSNS is already enabled.The default target cannot be
deleted.
iSCSITarget [Target Name] <delete>
iSCSITargetNameDisplay
Displays the iSCSI target name.
iSCSITargetNameDisplay
Route
Assigns a host protocol address to a target destination
device. If you try to map a new SCSI BTL to the same
iSCSI LUN, the new BTL overwrites the previous map.
Using the
Delete identifier removes the map from its map
table. In verbose mode, overwriting a map requires
secondary confirmation.
Route iSCSI [default | Target Name][lun] [SCSI [Bridge ]
| Delete] <bb tt ll>