RMBC64-24D ELECTRONIC BATTERY CHARGER
Introduction
Handling Requirements
Maximum stacking height.
2 x Units on top of each other.
Minimum clearance for ventilation.
25mm each side and 50mm at rear.
Power requirements.
110 >240 volts AC @ 6.5 Amps.
Weight.
16.5Kgs.
Dimensions.
200 x 380 x 570mm (H x W x D)
Installation.
Remove front cover by un-clipping side clips.
Check that the power switch is in the
OFF
position.
Lower back flap by twisting anti-clockwise “Zuse” fasteners to expose
mains input socket and ventilation fans.
Ensure both charger and mains is switched
OFF
before connecting power
lead to charger socket. Ensure both charger socket and power lead are
clean and dry before connecting.
Connect power lead (RMBCPL) by pushing plug into socket via locating
pins.
Connect charger lead (RMBCL24) plug to the 41 pin Amphenol socket
located on the front of the charger panel and charger lead socket to the
HAWK battery charge input plug.
The charger is ready for use.
