Mechanical settings
US
-
2000
(
DCP 2000 V
V5)
SERVICE MANUAL
CE
Fertigstellung: 02.16
US - 2000
g
g
Serviceanleitung_US2000V5_EN_V0.0.docx
Page 8 of 23
2.3.2. Adjustment for a parallel weld
To achieve an optimum (even) seal, the angle of the anvil can be adjusted with shims underneath the back side of
the anvil-guides.
1.
Bring the machine with the service mode in the
infeed position (anvil in the front but not clamped).
2.
Remove all 4 screws from the bronze guides
(Please note, that there are usually already shims
underneath the guides).
3.
Depending on what side you need to improve the
sealing, remove or add shims on the back side of
the guides (
Note:
only use precise grounded
shims
(ATS-Order No: BN1976 6x12x0.5
/
BN1976 6x12x0.2).
4.
Make sure you add or remove the same amount of
shims on the left and the right guide.
5.
Mount the guides with all 4 screws but do not
tighten them yet.
6.
Put the anvil all the way back between the guides.
7.
Adjust the play of the anvil by following steps of
section 2.3.1.
8.
Check the sealing again for a parallel welding
More shims in the back = more pressure
Less Shims = less pressure
Note:
Only add shims on the back side of the anvil as shown in the picture. Shims in the front of the anvil could
lead to an incomplete cutting of the band.
2.4.
Sonotrode slide
The sonotrode slide moves the sonotrode, knife and clamp along the vertical axis and has following
functions:
•
Clamps the band durring draw back between the anvil and clamp.
•
Presses the sonotrode against the anvil during the welding process.
•
Cuts the band.
