US
-
2000
(
DCP 2000 V
V5)
SERVICE MANUAL
CE
Fertigstellung: 02.16
US-2000
g
g
Serviceanleitung_US2000V5_EN_V0.0.docx
Page 21 of 23
Print mark (option)
4.
Print mark (option)
The print mark is used to position a printed band onto a product so that the print is always on the same position.
Turning on the print mark option:
1. Turn on the print mark:
Menu > Print mark.
2. Choose the print mark position:
Menu > Submenu > Process
settings > Print mark position.
Print mark on the side:
Set the print mark position to “0“.
Print mark underneath the welding:
Set the print mark position to
‘105”.
Setting the print mark underneath the sensor:
1. Press
<RESET>
to cut the band and remove it out of the
machine.
2. Pushing the release lever will release the band in the
channel; remove the band.
3. Press
<RESET>
again,
4. The
message
<Sensor S11>
appears on the display (the
brake of the driving shaft is now disengaged).
5. Feed the band back into the track by following the feeding
diagram.
6. Open the front door and turn the feed roller
counterclockwise until the band becomes visible at the
clamp (cutter).
Fig. 3
7. Pull on the band (Fig. 3) until at least one print mark becomes visible for marking.
8. Mark the band from the middle of the print mark
55 mm
in infeed direction (Fig. 2). Copy the mark onto
the back side of the band.
9. Turn the feed roller clockwise until the mark is located on the cutting edge of the clamp (Fig. 3). The
print mark is now exactly above the reading head.
Fig. 2
Fig. 1
