MC22LV SERIES
– MASTER CLOCKS
REV 3/17/15
APPLIED TECHNICAL SYSTEMS
PAGE 10
4.8 BASIC PLAN
The next step of the AUTO-PROMPT sequence is basic plan programming. Refer to Chapter 6.0
PROGRAMMING for details on entering your basic plan.
Note
: Setting Annuals is not included in the auto prompt sequence. See ENTERING,
REVIEWING OR EDITING THE ANNUAL PROGRAM(Section 6.3).
5.0 OPERATION
This section will explain how to change or review the existing time, date or programs previously
stored, how or how to totally program the unit after exiting the AUTO-PROMPT sequence. It
describes how to manually invoke each mode from the command line. You must be in the time
display before you can enter a command. Press the [EXIT] key to be sure. The display should
look similar to the following:
5.1 EDITING TIME [3] [ENTER]
Press the TIME key [3]. The display will respond with:
Press [ENTER]. The display will respond with:
Now you may enter the time as you would during the AUTO-PROMPT sequence. (see Section
4.3 APPLYING POWER, ENTERING THE TIME)
5.2 REVIEWING OR EDITING THE DATE
[D] [ENTER]
You must be in the time display in order to enter the date. Press the DATE key [D]. The display
will respond with:
Press [ENTER]. The display will respond with:
Enter the date as described in Section 4.4 ENTERING THE DATE.
Command? 03
Press ENTER
Time? 12:34 AM
Hrs. (HH), ENTER
Command? 0D
Press ENTER
Date? 12-29-15
Month (MM), ENTER
Mon 01:18:00 PM
Relays: - -
