MAN - BBR2S - REV: Original | E. Operation
31
contact the Applied Test Systems Service Department at +1-724-283-1212.
E.7 Test Setup
Test setup is used to define a BBR2S test specification as well as the type of report it will generate. When you press
the SETUP button the screen shown in Figure E.7 will display.
Test Name
The name of the currently selected test specification. The only limit to the number of tests that can be stored is the
size of the disk drive in the computer system. Since a test specification takes about 1K of storage space, it would
be nearly impossible to run out of space on the drive. You can use the “Test Name” combo to select different test
specifications already saved. Just press the down arrow button to get a list.
Test Date
Shows the last time that the currently selected test was saved.
Saving Test Parameters
The “Save” button will save all the current screen data to the currently selected test specification.
This should be done any time you change anything that you want to keep.
If you exit this screen without pressing
SAVE you will lose any changes you have made.
Copying a Test
The “Copy” button is used to make a copy of a test specification under a new name. This is useful if you wish to
make a new test with only a couple of changes from a currently save test.
Remember to press SAVE once you have the changes you want.
If you exit this screen without pressing SAVE
Figure E.7 - Test Setup Main Screen
