Atrump AL52, Operation & Maintenance Manual, Page: 16 / 110

Machine Safety Regulation
1-11
1.4 Machine Safety Description
1.4.1 Note before Operation:
1.4.1.1 Danger:
Before starting to operate this machine, please check and confirm all
cables and wire isolation whether they are damaged or not to avoid electric
shock.
1.4.1.2 Warning:
1.4.1.2.1 Understand completely every operation procedure and description on
the manual.
1.4.1.2.2 Wear safety clothes, oil-proof safety shoes, toggles with side shield and
other protective equipment.
1.4.1.2.3 Shut off NC unit, operation panel, electrical control penal and guards.
1.4.1.3 Caution:
1.4.1.3.1 Power supply must be sufficient to keep all equipment and machine
running smoothly.
1.4.1.3.2 It must be well protected for cable placed on the ground to avoid contact
with chip as to cause shortage.
1.4.1.3.3 When machine is unpacked or has not been used for a period of time (a
few days or longer), every sliding part must be cleaned and lubricated
and turn on lubricant pump for a while until lubrication oil has lubricated
all the parts before operating it again.
1.4.1.3.4 About lubrication oil viscosity, brand and equivalent grade, please refer
to indication plates or
Operator
’
s & Maintenance
manual on
chapter 3.6.3
1.4.1.3.5 Check all switches, buttons and operation levers can be operated
smoothly.
1.4.1.3.6 Please turn on main power as following procedure:
Turn on factory's main power supply

Turn machine’s main power no
fuse breaker to
"ON" or "
I
"

Depress green power push button "ON" on
operator's panel to turn on controller and CRT.
1.4.1.3.7 Check oil quantity in oil tank. Fill it to the required indication if necessary.
1.4.1.3.8 Check coolant quantity, fill it if necessary.
1.4.1.3.9 Please check whether the stand-by signal light is on or not after turn on
controller.