background image

3

ATOMIKRC.COM

18010

Import Safety Warning Cont.

Failure to observe any of the following precautions can 

result in fire, explosion and cause personal injury. 

Charging Instructions & Safety Warnings

1. Do to international shipping regulations, LiPo batteries are not shipped fully charged. All Venom LiPo battery packs should be fully charged prior to the 

first use.

 

2. Always use a charger specifically designed for LiPo batteries. Never use NiCD or NiMH chargers to charge LiPo batteries.
3. Charge each battery pack individually. Never charge battery packs in series. Charging packs in series may result in improper charger cell recognition, 

improper charging rate, and over charging that may lead to a fire. We recommend using a Venom LiPo balance charger when charging your LiPo 

batteries.

4. Venom LiPo batteries, 2S and greater, feature a separate balancing plug that isolates each cell in a pack and allows each to be charged and 

monitored independently. This ensures that all cells charge equally and discharge at the same rate during use. Never charge a 2S or greater LiPo 

battery without connecting the balance lead to the charger. Always balance charge a 2S and greater LiPo battery.

5. Make sure the battery connections are connected in the proper polarity. 
6. Always check to make sure that your LiPo charger settings match those listed on the battery pack label. Refer to the battery label for the proper cell 

count and 1C charging amperage setting. 

7. For the longest lifecycle and most thorough charging of your LiPo battery, we recommend a 1C charge rate. Many Venom batteries are capable of 

higher charge rates to reduce charge times. While your charge time will be greatly reduced, the lifespan of your pack will also be reduced with 

repeated charging above 1C. Always confirm and follow your specific packs maximum charge rate as shown on the battery label. For more information 

on how to determine your 1C charge rate please contact Venom.

 

8. Do not charge LiPo batteries to more than 4.2 Volts per cell or 4.35 Volts per cell for High Voltage (LiHV) LiPo batteries. Refer to the label of your 

specific battery for maximum cell and pack voltage. 

Important Information Regarding Over-discharge & Safety Warnings

1. Do not use LiPo battery packs with any device that does not have over-discharge protection, which is turned on and properly calibrated. Over-discharge 

protection or low voltage cut-off (LVC) should be set to no lower than 3.0V per cell.

2. Batteries should be stored at 3.75-3.80 volts per cell. Do not store batteries with voltage above or below this range for longer than one week. Check cell 

voltage with a LiPo Checker such as Venom (part # 0644 or 0699) by following the included instructions. 

3. LiPo batteries must be fully charged and returned to the recommended storage voltage range (3.75-3.80 volts per cell) at least once a month.
4. Do not discharge LiPo batteries below 3.0 Volts per cell. 
5. Never allow your model to discharge a LiPo battery pack at more than the recommended continuous discharge rate. Refer to the label of your specific 

battery to determine the proper continuous discharge rate. You must also refer to your specific vehicle user manual to ensure your batteries continuous 

discharge rate is not exceeded.

6. Be sure to disconnect battery packs from any and all device immediately after use.

Battery Disposal Instructions & Safety Warnings

1. Any battery that has been subjected to conditions outside of normal use, shows signs of swelling, “ballooning”, damage or has been retired from use 

should be disposed of properly.  We recommend transporting these battery packs to an approved disposal facility while observing the applicable safety 

warnings above. 

Failure to follow any of the instructions and safety warnings 

contained within this document may cause irreversible 

damage to the battery pack, charger or to your model. 

2. Check with your local waste facility to determine if they can handle disposal of lithium batteries and if they are permitted. Many stores also offer free 

recycling of rechargeable batteries. To find a drop-off location near you please visit: http://www.call2recycle.org/locator

Summary of Contents for 18010

















Reviews: