ATN MYGALE 23, Translation From The Original Manual

Page: 25 / 62

OPERATOR AND SAFETY MANUAL
1NO0040UK-01
Mygale 23
25
1- Control station selector:
Used to activate the controls from the platform control station or
from the ground control station. In position O, the key can be
removed to power the machine down.
2- Emergency Stop Switch:
In the event of an emergency, PRESS the button to CUT all the
movements from the machine and shut down the heat engine or the
electric motor. Turn the button by a 1/4 to restore the electrical
power.
3- Hourmeter:
Indicates the total operating time for the heat engine.
4- Overload indicator:
This light flashes when the work platform's load capacity is
exceeded.
Refer to Section 5.2 LOAD CONTROL
5- Engine Fault Indicator:
This light comes on power up and must go out when the engine
starts.
When the engine is running, this light flashes if there is an alternator
fault: the alternator is no longer correctly recharging the battery.
When the engine is running, this light comes on steady when the
heat engine oil pressure is abnormally low or when the cooling fluid
temperature is abnormally high: CUT the engine as quickly as
possible.
Refer to section 4.2.3. HEAT ENGINE SAFETIES
6- System fault / Maintenance indicator:
This light flashes slowly when a maintenance / pre-scheduled
maintenance operation is required.
This light is on steady (and a alarm sounds) if there is a control
system fault.
Refer to section 5.3 SYSTEM FAULT.
7- Preheat indicator:
This light comes on during the preheating phase and goes off once
the engine starts.
Refer to Section 4.2 HEAT ENGINE OPERATION.
8- Platform rotation control:
Toggle the switch upwards to move the platform to the right or
downwards to move the platform to the left.
Refer to Section 4.5.2 ELEVATION .