ATN MYGALE 23, Translation From The Original Manual

Page: 22 / 62

OPERATOR AND SAFETY MANUAL
1NO0040UK-01
Mygale 23
22
OPERATING CHECKS 3.3.
Machine operation: Refer to Section 4. OPERATION.
CONTROL STATIONS 3.3.1

Ground Control Station
1- On power up, check the indicators light up and the good working order of the alarm
(Autotest).
2- Start the heat engine or electric motor and activate all the controls to check their good
working order. Check the movement stops when the control is released. Check the
movement stops when the enable button is released.
3- Check the emergency stop switch cuts all the movements as well as the heat engine or the
electric motor (the heat engine stops after about 2 seconds).
4- Heat engine (electric motor) stopped, check the good working order of the electric motor
(heat engine).

Platform Controls Stations
1- On power up, check the indicators light up and the good working order of the alarm
(Autotest).
2- Start the heat engine or electric motor and activate all the controls to check their good
working order. Check the movement stops when the control is released. Check the
movement stops when the enable pedal is released.
3- Check the machine switches to slow speed when the work platform is raised.
4- Check the machine switches to slow speed when the telescope is extended.
5- Check the emergency stop switch cuts all the movements as well as the heat engine or the
electric motor (the heat engine stops after about 2 seconds).
6- c).
TILT INDICATOR 3.3.2
1- Platform lowered, drive the machine on a slope greater than 15%: the tilt light comes on.
2- Flashing ground contact indicator (ground contact condition and -0.2° <tilt< 0.2 ° not
fulfilled), the control of the structure elevation results in the actuation of the alarm and the
elevation function is disabled.
3- Once the machine is raised, if the tilt exceeds 1.5° the tilt indicator will light up. If the tilt
exceeds 1.5° the alarm comes on and only the lowering movements and telescope retraction
movements are allowed.
4- Check the movements are disabled depending on the selected operating mode (refer to
0Section 5: SAFETY DEVICES ).