AT-OME-SW32
9
Panel
Description
OUTPUT
DC 24V
INPUT
2
AT-OME-SW32
RS-232
LAN
1
3
1
2
L
+
+
AUDIO OUT
R
RX TX
IP MODE
RESET
AUDIO OUT
L
R
+
+
RS-232
RX TX
AT-OME-SW32
FW
2
1
2
1
PWR
OMEGA
TM
3
OUTPUT 1
3
OUTPUT 2
DISPLAY
1 PWR LED
Illuminates green when receiving power.
2 FW port
Connect a mini USB cable from this port to a PC to
firmware update the unit.
3 OUTPUT 1 & OUTPUT 2
Use the button to switch between sources, the LEDs
will illuminate to show the selected source. Output
two button and LED will only be functional in Matrix
Mode.
4 DISPLAY button and LED
Press the display button to trigger an on/off
command for the display. The LED will blink while
the command is being sent. By default, the display
button will mute the video output of the HDMI ports.
5 IP MODE button and LED
Press and hold the button for 10 seconds until the
LED blinks. The LED will blink 4 times for HDCP and
2 times for static IP.
6 RESET button and LED
Press and hold the button for 10 seconds until the
unit resets. The LED will blink as the unit resets to
factory default settings.
7 INPUT
Connect the USB-C or HDMI sources to these ports.
8 OUTPUT
Connect HDMI cables from these ports to HDMI
displays.
9 AUDIO OUT
Connect to an audio DSP, amplifier, or other audio
distribution devices.
10 RS-232
Use for device or display control.
11 LAN
Connect an Ethernet cable from this port to a Local
Area Network (LAN).
12 DC 24V
Connect the included DC 24V power supply to this
port.
7
6
8
9
10
11
12
3
1
2
5
4
