AT-ANC-108D
10
Installation
Power Connector
NOTE:
The DC 5V connector is only required if the AT-ANC-108D is not connected to a PoE-
capable network switch. If a PoE-capable switch is unavailable, refer to the instructions below to
connect the power supply. The power supply and captive screw connector are not included.
To purchase the power supply, contact Atlona.
Locate the included orange 2-pin captive screw terminal block and wire the included captive screw terminal block, as
shown below. Do not use high-torque devices, when securing the wires to the terminal block, as this may damage
the screws and/or the block.
1. Insert the wires into the correct terminal on the included captive screw terminal block, as shown below.
2. Tighten the screws to secure the wires. Do not use high-torque devices as this may damage the screws and/or
terminal block.
White (positive)
Black (negative)
