PAGE
13
DOC: 1310B
REV: 10-12
LC372SR SOUND REINFORCEMENT MODULE
INSTALLATION INSTRUCTIONS
CONFIGURATION
The
SCS Endpoint Configurator
application provides access to all the necessary setup operations that must be performed
on an LC372SR Sound Reinforcement Module before it can be used in a system. It also provides access to additional
setup features, such as EQ, that are configured upon installation and not adjusted as part of normal system operation.
This section covers the steps required to configure an LC372SR device and is not intended to provide comprehensive
coverage of the
SCS Endpoint Configurator
tool. Refer to the included help file for additional information on the
Configu-
rator
.
Start the SCS Endpoint Configurator Application
First, locate the
SCS Endpoint Configurator
on your computer. If you are using the system server, it should be located
on the desktop or available and appear as the icon shown in Figure 15. If a shortcut is not present on the desktop, go to
Explorer and look for
SCS Endpoint Configurator.exe
in the C:\IED\SRMICM Config Utility directory.
Figure 15 -
SCS Endpoint Configurator Icon
Once you have located the application, open it by double-clicking on the icon. If the application is running on the system
server, then you will immediately be taken to the discovery page shown in Figure 16
Figure 16 -
Discovery Window
It is possible to run the Configurator on a separate laptop or desktop computer to allow you to configure a device before
it is installed in the system. The system server computer also maintains a service that is responsible for automatically
assigning IP addresses to the devices in the system. If you are using a different computer, then this service will not be
running and the Configurator will give you a warning as shown in Figure 17
Figure 17 -
BOOTP Server Error
Select Yes and the Configurator will run its own BOOTP server to assign IP addresses to the device(s) you will be config-
uring. After selecting Yes, you will see the BOOTP Options window as shown in Figure 18. Enter the range of IP address
that the server will use by typing in a Start and Stop address. You must take care to ensure that this range is safe to use
on your network. Enter the appropriate Subnet Mask and click the OK button. Selecting CANCEL at any time will close
the window and the application will start without the BOOTP server running.
