13
ERROR CODES
Error codes are displayed with four characters, beginning with an E.
All error codes are found in the DS Drive Manual.
Group 0
Rundown failures, E000-E031
Group 1
Event related errors, E100-E131
Group 2
User input error, E200-E231
Group 4
Communication errors, E400-E431
Group 5
Hardware errors TOOL, E500-E531
Group 6
Hardware errors DC3000/MC3000, E600-E631
Error
code Description
Ack-
now-
ledge
What to do?
Help
text
E001 Torque LO
No
Start button was probably released to early. Let
the tool ”finish” the tightening.
”Torque
value”
E002 Torque HI
No
The programming is bad. Please check the
programming and make sure that you have
some movement on the socket in the second
stage.
”Torque
value”
E004 Angle1 LO
No
Check programming or the joint.
LO°1
E005 Angle1 HI
No
Check programming or the joint.
HI°1
E006 Angle2 LO
No
Check programming or the joint.
LO°2
E007 Angle2 HI
No
Check programming or the joint.
HI°2
E101
Pset invalid
(Check sum
error)
Yes
Change Final target by the F2 function on the
Drive Key Pad and store it. Afterwards change
it back to its original value.
E108
Rundown
prohibited
due to key-
pad usage
No
Press on the SET or ENTER button on the key
pad until you see four dashes or dots on the
display.
E112 Rehit
No
You tried to tighten the fastener when it was
already tightened and Alarm On Rehit was
marked in TTDS/Configuration. Please unmark
Alarm On Rehit or retighten the fastener.
E115
Direction
uncertain
Yes
You have probably pressed the start button too
quick since last time. Please allow more time
between releasing the start button and trying
to start the tool again.
E120
Motortuning
failure
Yes
Redo the Motortuning. If this does not work,
service the tool.
E131
Tool Discon-
nected
Yes
Shut the drive off and connect the tool. Start
the drive.
E206
Pset nr
invalid
No
Two or more sockets are lifted at the same time
or pset 9 or higher is chosen.
