Atlas Copco PFD1500RA-180, Product Instructions

Page: 24 / 60

Installation EN PFD1500RA-180
24
© Atlas Copco Industrial Technique AB - 9836 6024 01
Reqired tools
■
Vise
■
Spanner
■
Allen key
■
Pin spanner
■
Hook wrench
Prerequisites
Before installing the indexer, make sure that the following components are removed:
■
Front part
■
Drill bit
■
Spindle
■
Spindle guard
1. Fasten the drill in a vise with rubber pads, with the air logic unit downwards and the drill handle to the
right.
2. Remove the adapter that fastens the front part using a spanner. Remove the screw on the right side
of the adapter hole using an allen key.
3. Put the large hole on the index housing in position over the adapter hole, with the push button
against you. If the index housing is put in correct position, the plug to the right of the screw hole will
now fit into the index housing.
4. Put the nut into the index housing, with the threads downwards. Tighten the nut with a pin spanner.
5. Put the waved washer and the shaft, with the splines downwards, into the index housing.
6. Push the button on the index housing so the nut easily moves down to the bottom. Tighten the front
nut on the shaft onto the index housing with a hook wrench.
WARNING Crushing Hazard
Do not operate the tool if the indexer is not properly locked! An unlocked tool may cause the
complete tool to rotate and cause severe property damage and bodily injury.
►
Make sure that the lock pin is flush to the nut surface with a tolerance level of less than
0.3mm above the surface.
Install the components in the list above after finishing the installation.