Atlas Copco PFD1500RA-180, Product Instructions

Page: 11 / 60

PFD1500RA-180 EN Product Information
© Atlas Copco Industrial Technique AB - 9836 6024 01
11
Model Spindle (rpm)
Velocity rapid
advance
(mm/s), ±10%
Velocity rapid
advance
(inch/s), ±10%
PFD1500RA-1200-R 1200 44.5 1.75
PFD1500RA-1330-R 1330 49.2 1.94
PFD1500RA-1770-R 1770 65.6 2.58
PFD1500RA-2360-R 2360 87.4 3.44
Feed rate
The feed rate of the drill must be balanced with the spindle speed. Make a selection from the available
combinations of feed rate in the table below to get the desired feed rate. Normally a feed cassette can de-
fine two feed rates. By turning it 180 degrees you can change the feed rates, as shown in the figure below.
Feed cassette
IPR mm/rev Ordering No.
0.001 0.023 4141 0034 91
0.002 0.05 4141 0034 92
0.003 0.075 4141 0034 93
0.004 0.10 4141 0034 94
0.006 0.16 4141 0034 95
0.008 0.21 4141 0034 96
0.010 0.27 4141 0034 95
0.013 0.33 4141 0034 94
0.014 0.36 4141 0034 93
0.015 0.38 4141 0034 92
0.016 0.42 4141 0034 91
Service Overview
Service Recommendations
Preventive maintenance is recommended at regular intervals. See the detailed information on preventive
maintenance. If the product is not working properly, take it out of service and inspect it.
If no detailed information about preventive maintenance is included, follow these general guide-
lines:
■
Clean appropriate parts accurately
■
Replace any defective or worn parts