Manufacturing the adapter
plate
Construction Tools GmbH also supplies base plates
to manufacture adapter plates alternatively to the
adapter plates supplied.
NOTICE
Adapter plate cracking
The adapter plate may crack if it is not designed for
the high load.
►
Take not only the weight of the hydraulic
attachment but also the crowd force of the carrier,
possible vibration etc. into account when
dimensioning the adapter plate.
►
Ensure that the design conforms to the state of
the art.
►
Have the web plates welded to the adapter plate
base plate by a qualified welding specialist.
The base plate is made of the material
EN10025-S355 J2G3.
♦
Have the web plates designed and manufactured
or procure web plates to fit your carrier.
♦
Ensure that the web plates are welded to the base
plate side marked "TOP".
The adapter plate must not strike in any position
during operation of the hydraulic attachment.
Construction Tools GmbH does not design,
manufacture or sell web plates for adapter plates.
Installing the adapter plate
NOTICE
The adapter plate can come loose
The adapter plate can come loose if the fastening
screws are not designed for local high loads.
►
Only use the Allen screws of strength category
8.8 and the pairs of lock washers included in the
delivery to attach the adapter plate or the base
plate.
♦
Place the hydraulic demolition cutter on timber
support blocks within the range of the carrier. With
the data plate facing upwards. It is on the upper
part of the hydraulic demolition cutter.
♦
Apply anti-seize compound to the Allen screw
threads (A) before inserting them.
The contact faces of the screw head and the lock
washers (B) must not be lubricated.
WARNING Hands and fingers being cut off
or hurt
Bores and surfaces can act like a pair of scissors
and cut off or hurt parts of your body.
►
Never use your fingers to check bores or fitting
surfaces.
♦
Align the adapter plate (D) to the upper part (C)
of the hydraulic demolition cutter as shown.
A
B
C
D
♦
Fit a pair of lock washers (B) onto every screw.
♦
Tighten the Allen screws (A) with an Allen key.
♦
Tighten the Allen screws (A) with the required
tightening torque.
Tightening torque
Key size
390 Nm
17 mm
1500 Nm
22 mm
Attaching the hydraulic
attachment to the carrier
Mechanical mounting aspects
You need an assistant to attach the hydraulic
attachment to the carrier.
♦
Agree on hand signals with your assistant, to
enable him to help you place the carrier in the
proper position to attach the hydraulic attachment.
♦
Lower the stick of the carrier into the holder
provided on the adapter plate.
23
© 2015 Construction Tools GmbH | No. 3390 5141 01 | 2015-11-16
Original instructions
INSTALLATION
CC 1700 U, 1700 S
