●
to hit or chop
This destroys the hydraulic demolition cutter.
●
as a crow bar
This destroys the hydraulic demolition cutter.
●
to push debris
This destroys the hydraulic demolition cutter.
●
to move the carrier supported by the hydraulic
demolition cutter
This severely damages the hydraulic demolition
cutter.
●
to lift or transport loads
This damages the hydraulic demolition cutter.
●
under water
This destroys the hydraulic demolition cutter and
may damage the whole hydraulic installation.
●
in explosion-hazard environments
Explosions cause serious injury or death.
Protective equipment
Personal protective equipment must comply with the
applicable health and safety regulations.
Always wear the following personal protective
equipment:
●
protective helmet
●
safety glasses with side protectors
●
protective gloves
●
protective shoes
●
warning vest
Carrier, precautions
WARNING Falling carrier
●
If the load-bearing capacity of the carrier used is
insufficient, the carrier will not be stable. It can
topple over and cause injuries and damage.
●
Using a carrier whose load-bearing capacity is too
high, may cause mechanical overloading of the
hydraulic demolition cutter.
►
Only attach the hydraulic demolition cutter to a
hydraulic carrier of a suitable load-bearing
capacity.
►
The carrier must remain stable at all times.
►
Read the carrier manufacturer's Safety and
Operating Instructions before attaching the
hydraulic demolition cutter to the carrier and
operating it. Observe all instructions.
Transport, precautions
WARNING Risk of death due to suspended
loads
When lifting loads these can swing out and fall. This
can result in serious injuries or even death.
►
Never stand underneath or in the swinging range
of suspended loads.
►
Only move loads under supervision.
►
Only use approved lifting equipment and lifting
gear with sufficient load bearing capacity.
►
Do not use worn lifting gear (ropes, belts, chains,
shackles etc.).
►
Do not place lifting gear such as ropes and belts
on sharp edges or corners, do not knot these or
twist them.
►
When leaving the workplace, set down the load.
WARNING Injury due to swivelling load
When transporting the load by crane it can swivel
and cause severe injuries and considerable damage
to property.
►
Ensure that no personnel, objects or obstacles
are located in the swivel range of the load.
Hydraulic installation,
precautions
WARNING Hydraulic pressure too high
If the hydraulic pressure is too high, the parts of the
hydraulic attachment will be exposed to excessively
high loads. Parts can break loose or burst causing
serious injuries.
►
Lay the drain line of the pressure relief valve
directly in the tank to ensure the safe functioning
of the pressure relief valve!
►
The pressure relief valve must be set at the
maximum static pressure.
►
The pressure relief valve setting must be checked
to ensure that the maximum static pressure (see
chapter
Technical specifications
) of the hydraulic
installation is not exceeded at any time. Attach a
lead seal to the pressure relief valve.
►
Prior to their first use, the safety facilities on the
hydraulic installation must be checked by a
professional/authorised monitoring body for their
quality (CE mark etc.), suitability and proper
functioning.
11
© 2015 Construction Tools GmbH | No. 3390 5141 01 | 2015-11-16
Original instructions
SAFETY INSTRUCTIONS
CC 1700 U, 1700 S
