GLASS RECEIVER CHANNEL MUST BE INSTALLED ONTO THE WATERPROOFING BEFORE THE WALLS ARE
TILED
INSTRUCTIONS FOR FX-NTRB
CONFIGURATION
1.
Position the glass receiver channel over the base
glazing channel. Use
a straight edge and
mark the wall to
indicate where the
wall channel is
plumb.
2.
Apply a silicon seal
to full length of
channel. Silicon
used must be
compatible with
anodised
aluminium as well
as the
waterproofing
being used.
3.
Ensure the glass receiver channel is located firmly
over the base glazing channel. The machine recess
in the wall glazing
channel must firmly
locate over the base
glazing channel.
Locate the framing
timber. Use the
4mm drill bit to drill
holes through the
glass receiver
channel. Fix four
screws through the
channel in the wall framing (use wall plugs if
required).
4.
Apply a continuous bead of silicon to the full
length of the
channel and
waterproofing,
indicated by the
dark line (inside
channel).
5.
Slide the sill infill into position and apply 6mm
plastic packers
into the base
glazing channel in
locations as
shown.
6.
CRITICAL SEAL
Remove the dust and
dirt first. Seal the
connection between
the glass receiver
channel and the base
glazing channel with
clear silicon, prior to the installation of panel
21 B.
Ensure the corner junction between wall channel
and base channel is full of silicon before final glass
placement. It is vital that
all junctions are sealed
sufficiently.
Prior to installation of
fixed panel and infill all
connections of channels
must be sealed with
clear silicon supplied.
7.
Locate the glass panel
21 B
into the glazing
channels. The top of the panels should align to the
top of the glass receiver channel.