Maintenance
Replacement diode assemblies are available for
Hardscape Lights. Remove the screws on the
existing light, being careful not to let the diode
assembly fall, as this could break the plug
connecting the light to the cord. Lower the diode
assembly and squeeze the locking clip to separate
the plugs. Plug in the new diode assembly, making
sure the gasket has not moved or shifted and that
the notched edge of the diode assembly fits
between the two ridges on the cord gasket. Align
the screw holes and hand tighten the screws.
5
WIRING KITS - CCSM30X3
All Color Changing LED lights and wiring components
are connected via a quick-connect plug. Color Changing
LED Lights will not operate if plugs are aligned incorrectly. The connectors are keyed to ensure
the connections line up properly. Color Changing quick-connect plugs carry both AC and DC
current to the in-line driver. Moisture entering the connections will allow the AC and DC
current to cross which can damage the lighting system.
Quick-connect plugs are gasketed for outdoor use and must be fully tightened to
prevent water infiltration. Quick-connect plugs are not waterproof and should not be
submersed. Dielectric grease is included and should be used in all connections to eliminate
water infiltration.
The CCSM30X3 wiring kit enables up to three Color Changing lights (any models) to be
installed together and controlled by a single transformer, Smart Module and App. The
transformer must be plugged into a properly grounded GFCI outlet. Please follow the
connection diagram below for proper installation.
BAR LIGHT - CCBL5
Installation
The Bar Light is a linear light designed to wash
walls, falls and spillways with a wide beam angle.
Solid brass Bar Light includes dual bases for
positioning on any horizontal surface. For other
applications, included stainless steel L-brackets
may be used to mount Light to any hard surface.
Mount the brackets to the light and measure
between the holes, center to center. Detach the
brackets from the light. Mark where the light is
to be mounted and attach the brackets to the
mounting surface using an appropriate fastener.
Mount the light to the brackets. The mounted
Light rotates 30° in either direction for versatility in
directing illumination.
FOUNTAIN LIGHT - CCFL2
Installation
Atlantic’s epoxy encased Fountain Light illuminates water inside
vases, basalts and bubbling boulders. The PVC body with bottom
mounted cord fits inside 11/2” socket fittings and 2” bore holes.
Glue the 3/4” slip x 3/4” barbed fitting, included, to attach 3/4”
Kink-Free tubing directly to Fountain Light. Without the fitting,
the light mounts directly onto 3/4” rigid Sch40 PVC.
InfiColor Smart Module
30 Watt
Transformer
LIGHT #1
LIGHT #2
LIGHT #3
