EN
45
EN
4.4.
Horizontal wall-mounted water heater- Side connection
fi gure 1
x 2
fi gure 2
Installation Manual: Fitting the water heater - Water heater water connections
Mounting procedure:
- Assemble the belts and brackets using the nuts and
bolts in the package without tightening them (fi gs. 1 and
2)
- Fit the brackets with their belt on the support (wall, cei-
ling, fl oor), then tighten
- Position the water heater using one of the 4 mounting
options.
- Complete the mounting procedure by tightening the belt
nuts on the bracket
Essential:
Align the pick-ups vertically with the hot water outlet (red) above the cold water
(blue).
5.
Water heater water connections
The water heater must be connected in accordance with the standards and regula-
tions in the country in which it is installed (for France: DTU Plumbing 60-1).
5.1. Conventional connection
u
Connect the NEW safety unit to the cold water inlet (blue) on your water heater.
v
Place the siphon under the safety unit and connect its drain pipe to the drain.
w
Tighten the dielectric connection onto the hot water outlet (red) on your water heater.
x
Tighten your pipes on your water heater.
WARNING
Your pipes must be rigid (copper) or fl exible (standardised braided stainless steel hoses)
and able to withstand 100°C and 1 MPa (10 bar). Otherwise, use a temperature limiter.
CEILING
FLOOR
WALL
Waste water
drainage
Hot water connection
Cold water connection
Dielectric
connection
NEW
safety unit
applied in
the direction
of screwing
MANDATORY
MANDATORY
Siphon
Summary of Contents for 021116
Page 8: ...FR 6 ...
Page 38: ......
