IP SIP Phone v2
User’s Guide
Mar. 2005
[48/100]
transfer from call-A to call-B, you should press
【
Conference
】
to conference both
parties in.
9.4.2. Blind
Transfer
Follow the following steps to do a blind transfer: transfer the call without asking the
transferring target first.
z
Set up a connected call to party-A
z
Press
【
XFER
】
to put A on hold and gain dial-tone.
z
Dial the target number of party-B
without
an ending
【
#
】
; instead, you
SHOULD
press
【
XFER
】
immediately to transfer party-A to party-B; alternatively, you
MAY
just
hang up
(on B-channel) as soon as finishing dialing B’s number
without
an
ending
【
#
】
.
z
(Optional) During dialing phase, if you decide not to transfer but to take back
party-A, press
【
FLASH
】
to abandon blind transfer and take back A (alternative, you
may press
【
A/B Channel
】
to cancel blind transfer and take back A as well).
Note, if you press
【 】
#
to finish dialing, it behaves just the same as
consultative
transfer
.
Alternatively, you may do a blind transfer as follows:
z
Take an incoming call from party-A on
【
A Channel
】
.
z
Get an empty channel by pressing
【
B Channel
】
to perform a call switch (effectively
put A on hold), and gain dial tone.
z
Dial the target number of party-B
without
an ending
【
#
】
; instead, you
SHOULD
press
【
XFER
】
immediately to transfer party-A to party-B; alternatively, you
MAY
just
hang up
(on B-channel) as soon as finishing dialing B’s number
without
an
ending
【
#
】
.
Note, you can not transfer two inbound calls to each other. Instead, you can blindly
transfer each call to a third party. On which time, the channel LED in question,
【
A / B
】
,
will be
red
(v.s.
green
).
9.4.3. Phone
Locked
Under station lock, you can receive calls but not making calls. Moreover, you cannot perform
call transfer either. The phone will show the following alarm to warn you: