17
Description of device / spare parts
Â
Please refer to the attached assembly and
operating instruction sheet.
Pos. Denomination
Order-no.
1 Upper
handle
hoop
381856
2 Switch
handle
3 Safety
knob
4 Switch-plug
combination
381855
5
Cable strain relief
381858
6 Cable
clip
381859
7 Lower
handle
hoop
381857
8 Body
cover
9 Screw
bag
381853
10 Safety
label
381854
11 Handle
hoop
holder
381861
12 Protective
cover
13
Hoeing tool - right
381859
14
Hoeing tool - left
381860
Assembly
Safety switch
Open the holder for the switch-plug combination (4). Slide
the switch-plug combination (4) over the holes on the upper
handle hoop (1) and secure it using the provided screws
(2x ST3.9x19).
Handle hoop
Secure the lower handle hoop (7) on the hoop holders (11)
on the motor housing. Use the supplied fasteners (2x screw
M5x25, 2x lock nut M5).
Fasten the upper handle hoop (1). Use the supplied
fasteners (2x screw M6x45, 2x flying nut M6). Fix the cable
on the handle hoop using the cable clips (6). Make sure
that the cable has enough free motion.
Attach the cable strain relief (5) on the lower handle hoop
(7).
Start-up
Mains connection
Compare the voltage given on the machine model plate e.g. 230
V with the mains voltage and connect the machine to the
relevant and properly earthed plug.
Connect the machine via a circuit breaker switch (residual-
current-operated circuit switch) 30 mA.
Design of the connection cable according to IEC 60245 (H
07 RN-F) with a core cross-profile section of at least
-
1.5 mm² for cable lengths up to 25 m
-
2.5 mm
2
for cable lengths over 25 m
Mains fuse
10 A inert
Mounting of the extension cable
Plug the female connector of the extension cable on the
male connector of the switch-connector combination (4).
Thread the extension cable through the strain relief (5) as a
loop and hang it up.
L
Make sure that the extension cable has enough free
motion.
Switching on / off
Do not use any device where the switch can not be
switched on and off. Damaged switches must be repaired or
replaced immediately by the customer service.
The device is equipped with a safety circuitry preventing
inadvertent switching on.
Only start the machine when it is placed on a flat ground
area without obstacles.
Switching on
Tilt the device slightly towards you.
Push the safety button (3) and keep it depressed.
Next, pull the switch lever (2) toward the handle (1). The
device starts and the blade drum can rotate freely.
L
Now release the safety button (3).
Switching off
When you release the switch lever (2) it returns automatically to
its original position.
Motor protection
The motor is equipped with a protective circuit breaker and
switches off automatically in case of overloading. After a
cooling-down break (approx. 15 min), the motor may be
restarted.
Release the switch lever (2) because the device will
otherwise restart immediately after it has cooled down.
Risk of injury!
Before start of work
Before starting any work ensure the following:
You may not start to operate the machine until you have read
these operating instructions, observed all the instructions
given and installed the machine as described!
Provide for a safe and cleaned workplace. Remove from the
working area objects which might be thrown off.
Before starting your work make sure that:
−
the tools and bolts are not worn or damaged. To avoid any
unbalance worn or damaged tools and bolts must only be
replaced as a whole set.
−
the hoeing tools are in a proper condition
−
all screw connections are firmly tighten