ATI
Q46/84 Hydrogen Peroxide Monitor
Part 4 – Electrical Installation
21
O&M Manual
Rev-H (6/17)
4.6
Junction Box Connection
For installations where the sensor is to be located more than 25 feet from the monitor (max. 100
feet), a junction box must be used. The junction box is shown in Figure 15, and is supplied with a
½" conduit hub on one end and a sensor cable gland on the other end.
NOTE: If sensor is experiencing Low-Slope or Low-Output conditions, due to poor Earth
Ground Connections, move the Shield connection from P/S board to alternate location on
lid, where indicated with an “S”.
Figure 15 - Junction Box Interconnect Wiring
