Manual, Flexdeburr, RS-340
Document #9610-50-1016-08
Pinnacle Park • 1031 Goodworth Drive • Apex, NC 27539 USA • Tel: +1.919.772.0115 • Fax: +1.919.772.8259 • www.ati-ia.com • Email: [email protected]
32
8. Apply a thin film of the Magnalube to the housing bore where the ring cylinder seats prior to
installation.
9. Apply Magnalube to the (2) new o-rings, if the old unit is being reinstalled. (Do not reuse the
old o-rings.)
10. Install the new o-rings to the outside of the ring cylinder assembly.
11.
Align the shallow drill point on the ring cylinder body to the 2 mm dowel pin hole on the rear
housing prior to pressing the ring cylinder into the bore. Insert the new ring cylinder assembly
into the rear housing.
12. If the (2) M3 socket head cap screws do not have pre-applied adhesive, apply Loctite 222 to the
threads.
13.
Using a 2.5 Allen wrench, secure the ring cylinder assembly to the rear housing using the (2)
M3 socket head cap screws. Tighten to 12 in-lbs (1.4 Nm).
14. Assemble the rear housing to the front housing.
15. If the (6) M3 socket head cap screws do not have pre-applied adhesive, apply Loctite 222.
16. Using a 2.5 Allen wrench, secure the rear housing using the (6) M3 socket head cap screws.
Tighten to 12 in-lbs (1.4 Nm).
17.
Install the deburring tool to the robot or workpiece location.
18.
Safely resume normal operation.