Manual, Flexdeburr, RS-340
Document #9610-50-1016-08
Pinnacle Park • 1031 Goodworth Drive • Apex, NC 27539 USA • Tel: +1.919.772.0115 • Fax: +1.919.772.8259 • www.ati-ia.com • Email: [email protected]
23
ATI can provide guidance in the bur selection, however, only experimentation will yield the results
desired. The following table is presented to assist in the burr selection.
Table 4.1—Bur Selection
Materials/Application
Features/Benefits:
9150-RC-B-24033 - Diamond Cut, 1/4” Bur Diameter, 5/8” Bur Length, 1/4” Shank
•
For hardened and tough materials,
super alloys, and stainless. steel,
alloyed cast steel and fiber reinforced
plastics
•
Edge and surface working
•
Built up Welds of high-tensile strength
in mold and die making
•
Higher cutting capacity than
standard cuts
•
Smoother finish for surface
treatments
•
Lower axial force than ADC
9150-RC-B-24061 - Standard Cut, 3/8” Bur Diameter, 3/4” Bur Length, 1/4” Shank
•
For steels of high tensile strength
die steels, cast steel, built up welds,
tough materials, and welds
•
For beveling
•
For chamfering
•
For deburring
•
Without chip breaker, for
scratch-free surfaces
9150-RC-B-24063 - Diamond Cut, 3/8” Bur Diameter, 3/4” Bur Length, 1/4” Shank
•
For hardened and tough materials,
super alloys, and stainless steel,
alloyed cast steel and fiber reinforced
plastics
•
Edge and surface working
•
Built up welds of high-tensile strength
in mold and die making
•
Higher cutting capacity than standard
cuts
•
Smoother finish for surface
treatments
•
Lower axial force than ADC
.
9150-RC-B-24065 - Aluminum Cut, 3/8” Bur Diameter, 5/8” Bur Length, 1/4” Shank
•
For greasy aluminum alloys,
soft non-ferrous metals and
thermoplastics
•
For use on cast aluminum
•
Easy chip flow through positive
rake angle, rounded base of tooth,
convex tooth back
•
No loading of the flutes, not even
while cutting sticky metals
•
Smooth operation due to the
peeling effect of the teeth
9150-RC-B-24645 - Aluminum Cut, 3/8” Bur Diameter, 5/8” Bur Length, 1/4” Shank
•
For greasy aluminum alloys,
soft non-ferrous metals and
thermoplastics
•
For use on cast aluminum
•
Easy chip flow‑through positive
rake angle, rounded base of tooth,
convex tooth back
•
No loading of the flutes, not even
while cutting sticky metals
•
Smooth operation due to the
peeling effect of the teeth
