Manual, Flexdeburr, RS-340
Document #9610-50-1016-08
Pinnacle Park • 1031 Goodworth Drive • Apex, NC 27539 USA • Tel: +1.919.772.0115 • Fax: +1.919.772.8259 • www.ati-ia.com • Email: [email protected]
30
Figure 6.2— Turbine Motor Replacement
Garter Spring
(6) M3 Button Head Cap Screw
Boot Retainer Ring
Boot
Wave Spring
(Magnalube)
(2) Pivot Pin
Supply Boot
Internal Retaining Ring
Spindle Motor Air
Supply Fitting
Motor
Assembly
Rear Post
(Manalube)
Rear
Housing
Assembly
(6) M3 Socket Head
Cap Screws
Set Screw
Magnalube Surface(s)
Coat the wave spring
with Magnalube and
position as shown
in the front of the
housing.
Compliance Air Fitting
20. Apply Loctite 222 to the (6) M3 socket head cap screws, if there is not pre-applied adhesive.
21. Align the rear housing to the front housing assembly and secure with the (6) M4 socket head
cap screws. Tighten to 12in-lbs (1.4 Nm).
22.
Slide the boot over the turbine motor spindle and align to the front housing assembly.
23. Apply Loctite primer 7649 and Loctite 222 to the (6) M3 socket button head cap screws.
24. Install the boot retaining ring over disk boot and secure with (6) M3 socket button head cap
screws. Tighten to contact and an additional 1/2 turn.
25.
Assemble the garter spring over the boot. (it will seat in the groove in the turbine motor
assembly)
26. Assemble the new internal retaining ring and supply boot to the spindle supply fitting as shown
27. Apply Loctite 569 to the threads of the spindle supply fitting.
28. Thread the spindle supply fitting into the turbine motor assembly until it is finger tight then
tighten an additional 1/2 turn.
29.
Slide the supply boot into the counter bore in the front housing.
30. Push the internal retaining ring into the counter bore to secure the rubber disk.
31. Install the bur tool, refer to
Section 6.2.1—Bur and Collet Replacement.
32.
Install the deburring tool to the robot or work location.
33. Safely resume normal operation.
