Manual, Robotic Deburring Tool, RCV‑490 Series
Document #9610‑50‑1032‑06
Pinnacle Park • 1031 Goodworth Drive • Apex, NC 27539 USA • Tel: +1.919.772.0115 • Fax: +1.919.772.8259 • www.ati‑ia.com
30
6. Install the new ring cylinder assembly.
a. Use light grease (NLGI‑2) to lubricate the bores in the entrance to the rear housing
assembly and the O‑rings in the new ring cylinder assembly.
b. Locate the alignment mark hole on the ring cylinder and align it with the drill point on
the rear housing.
c. Insert the ring cylinder slowly by hand while maintaining the orientation of the
alignment marks.
d. Using a 2.5 mm hex key, secure the new ring cylinder assembly to the front housing
assembly with the (3) M3 socket head cap screws. Tighten them to 12 in‑lbs (1.356 Nm).
7. Install the rear housing assembly.
a. Install the rear housing assembly to the main housing assembly.
b. Using a 3 mm hex key, secure the rear housing assembly to the front housing assembly with
the (6) M4 socket head cap screws. Tighten to 25 in‑lbs (2.825 Nm).
8. Connect the hoses to the fittings on the rear of the RCV‑490.
9. Install the RCV‑490 to the robot or work location.
10. Safely resume normal operation.
