® Copyright ATH-Heinl GmbH & Co. KG, All rights reserved / Misprints and technical changes reserved / As of: 2021-11
Manufacturer ATH-Heinl GmbH & CO.KG
- 27 -
6.2
FEEDING OIL AND BLEEDING RUNWAYS
Pay much attention: refill the oil if not enough during this procedure.
After bleeding, make sure to reset ordinary operating conditions. Lift cannot be lifted if a leveling cutoff
cock is opened.
Be sure ADJ/WORK selector
is set into the position “WORK”;
•
the runway P1 (the master runway: the left side from the view toward the vehicle head) is raised
only in this procedure;
b.
Keep pressing both the photocell pass-by button and the lifting button to until the runway P1 reaches
the top position;
d.
Raise the runway P1 again until it reaches the top position;
e.
Set ADJ/WORK selector
into the position “ADJ”;
g.
Press the lifting button to raise the runway P2 (the slave runway: the right side from the view toward
the vehicle head) until the platform reaches the top position. Pay attention to refill the oil;
h.
Press the lowering button to lower the runway P2 completely;
i.
Repeat raise and lower the runway P2 completely at least 5 times;
j.
Raise the runway P2 to the same height as the runway P1;
k.
Turn off the leveling cutoff cock 2 and set ADJ/WORK selector into the position “WORK”;
l.
Lower and raise the runways at least 3 times to check the level of runways. If not leveled, repeat above
procedure.
