ATEN SN0108CO, User Manual

Page: 127 / 178

Chapter 8. Device Management
111

Use the same Username/Group name on both the RADIUS server
and the Serial Console Server.
In each case, the user’s access rights are the ones assigned that were
assigned when the User of Group was created on the Serial Console
Server. (See
Adding Users
, page 82.)

LDAP / AD Settings
To allow authentication and authorization for the Serial Console Server via
LDAP / AD, refer to the information in the table, below:
Item Action
Enable Check the
Enable
checkbox to enable LDAP, and
Enable SSL
checkbox to enable LDAPS authentication and authorization.
LDAP Server IP
and LDAP
Service Port
Fill in the IP address and port number for the LDAP or LDAPS
server.

You can use the IPv4 address, the IPv6 address or the
domain name in the
LDAP Server
field.

For LDAP, the default port number is 389; for LDAPS, the
default port number is 636.
Alternate LDAP
Server and
Alternate LDAP
Service Port
Fill in the IP address and port number for the alternate LDAP or
LDAPS server.

You can use the IPv4 address, the IPv6 address or the
domain name in the
Alternate LDAP Server
field.

For an
Alternate LDAP Service Port,
the default port number
is 389; for an
Alternate LDAPS Service Port
, the default port
number is 636.
Admin DN Consult the LDAP / LDAPS administrator to ascertain the
appropriate entry for this field. For example, the entry might
look like this:
ou=kn4132,dc=aten,dc=com
Admin Name Key in the LDAP administrator’s username.