ATEN CS19208, User Manual

Page: 35 / 108

25
Chapter 3
Basic Operation
Hot Plugging
The CS19208 / CS19216 supports hot plugging – components can be removed
and added back into the installation by unplugging their cables from the ports
without the need to shut the unit down. In order for hot plugging to work
properly, the procedures described below must be followed:
Hot Plugging KVM Ports
In order for the OSD menus to correspond to KVM port changes, you must
manually reconfigure the OSD to reflect the new port information. See the
F3
SET (page 35) and F4 ADM (page 37), functions for details.
Note: If the computer's operating system does not support hot plugging, this
function may not work properly.
Hot Plugging Console Ports
The keyboard, monitor, and mouse can all be hot plugged. When hot plugging
the mouse:

You may unplug and replug the mouse (to reset the mouse, for example),
as long as you use the same mouse.
 If you plug in a different mouse, all the computers on the installation must
be shut down for 10 seconds, then restarted following the power up
sequence described under Steps 6, 7, and 8 under
Two Stage Cascade ,
page 19
Note: If, after hot plugging there is no response to keyboard and/or mouse
input, perform a
Keyboard and Mouse Reset by simultaneously
pressing the 1 and 2 (CS19208 / CS19216) front panel pushbuttons.