ATEN CS17916, User Manual, Page: 29 / 86

2. Hardware Setup
19
Single Stage Installation
To set up your single stage CS1798 / CS17916 installation, refer to the
installation diagram on page 20 (the numbers in the diagrams correspond to the
steps, below), and do the following:
1. Plug your USB keyboard and USB mouse into the USB console ports
located on the unit’s rear panel.
2. Connect your HDMI monitor into the HDMI console port and power on.
3. Plug your main speakers into the speaker jack located on the unit’s front
panel. The speakers plugged into this port have priority over those plugged
into the rear panel.
4. Plug your secondary speakers into the audio port located on the unit’s rear
panel.
5. Using the custom USB HDMI KVM cable set provided with this package,
plug the HDMI connector into any available HDMI socket in the KVM
port section of the switch, then plug the accompanying USB and audio
connector into their corresponding USB and speaker sockets.
Note: 1. Verify that all the plugs are in the same KVM Port sockets (all in
Port 1, all in Port 2, etc.).
2. The CS1798/CS17916 only supports speaker ports. Do not
connect a KVM cable's microphone connector to the speaker
ports.
6. At the other end of the cable, plug the USB, video, and speaker cables into
their respective ports on the computer.
7. Plug your USB peripherals into the type A sockets in the USB hub section.
8. Plug the power adapter that came with your switch into an AC power
source, then plug power adapter cable into the switch’s Power Jack.
9. Turn on the power to the computers.