ATEN ATEN VanCryst VM1600A, User Manual

Page: 53 / 204

Chapter 2. Hardware Setup
39
5. (Optional) Connect your speakers / audio output device(s) to the Audio
port(s) of the Output Board on the VM1600A.
6. (Optional) To access the web GUI or the Video Matrix Control app, plug a
Cat 5e cable from the network into the VM1600A’s Ethernet port.
Note: For more information on the Video Matrix Control app, see Video
Matrix Control App User Manual .
7. (Optional) If you are using a serial control function, use an appropriate
serial cable to connect the computer or serial controller to the VM1600A’s
female
RS-232 serial port.
8. (Optional) If you are using the serial control function to control multiple
VM1600A’s, use an appropriate serial cable to connect the computer or
serial controller to the VM1600A’s female
RS-485 / RS-422 captive
screw connector. The VM1600A package includes a terminal block
connector that can be used for this connection.
9. Install the power module.
a) Insert the supplied power module into the Primary Power Slot.
b) Plug one end of the supplied power cord into the power module.
c) (Optional) Use the cable strap to hold the power cord in place.
d) Plug the other end of the power cord to a power source.
Note: Make sure the power module is stabilized into the VM1600A unit
by gently pulling the power module. You should only be able to pull
out the power module as you press the release lever.
10. (Optional) For redundant power, plug in a power module to the Redundant
Power Slot.
Note: Secondary power modules are not part of the standard VM1600A
package. For more information on supported power modules, go to
https://www.aten.com/global/en/ .
11. Power on the VM1600A and all devices in the installation.