ATEN ALTUSEN IP9001, User Manual

Page: 27 / 140

JP2 - Serial Port Connector
You can connect an external 9 pin serial port connector to this header. This header is
primarily used to text redirect over the serial port.
JP3 - Service Connector
This jumper is used exclusively for servicing the IP9001 card. JP3 is not described in
this document.
JP4 and JP5 - Chassis/Motherboard Power Switch
JP4 and JP5 can be used in place of the IP9001 Feature Cable to power on, power off,
and power cycle the motherboard.
Connect a two pin cable from the motherboard’s Power (Soft On/Off) header to JP4
on your IP9001 card. Connect the chassis power switch to JP5 on your IP9001 card.
JP6 - IP9001 Reset Button
You can short this jumper to reset your IP9001 card.
Pin Description
1
Ground
2 Reset #
JP7 and JP8 - Chassis/Motherboard Reset Switch
JP7 and JP8 can be used in place of the IP9001 Feature Cable to reset the
motherboard.
Connect a two pin cable from the motherboard’s reset header to JP7 on your IP9001
card. Connect the chassis reset switch to JP8 on your IP9001 card.
Note: JP7 and JP8 can be used instead of the IP9001 Feature Cable to reset the
motherboard.
2005-06-09
17